Lofting

Available in TurboCAD Pro and Platinum only
Image Modified 
Creates a 3D object by connecting 2D profiles. The profiles lie on different planes, and the planes do not have to be parallel. The profiles are connected using NURBS (Non-Uniform Rational b-Spline) calculations.
The profiles can be closed or open, but they must be consistent - all open or all closed.

1. If you want to select only simple (single-object) curves, make sure sure Use Compound Profile is  is not selected selected. 
   Image Modified
2. Select the profiles, in the desired order. Selection order is important
3. Select Select Finish from  from the local menu, or double-click on the last profile, to create the loft.
   Image Modified

The loft has no sharp corners at the profiles.
To create corners, you can creates two separate lofts.
Image Modified 
If you use open profiles, a 3D surface will result.
Image Modified 
 
Lofting with Compound Profiles
A compound profile is an open or closed chain of connected curves. You can use compound profiles when you do not want to create a polyline, or convert a chain into a polyline.

1. Make sure sure Use Compound Profile is  is selected.
   Image Modified
2. Select the compound profile, which is automatically identified as a chain. To deselect any curve in the chain, select it again (it will turn green). In this example, Profile 1 is a series of connected lines, not a polyline.
   Image Modified
3. When the profile is selected, click click Finish Selection of Profile, or select it from the local menu.
4. Select the next profiles using the same steps. If subsequent profiles are simple (not compound), you can turn off off Use Compound Profile. Image Removed
   Image Added
5. When the last profile is selected, click click Finish or  or select it from the local menu.
   Image Modified 
   Note: Compound  Compound profiles can be modified, which updates the 3D objects upon which they are based. See See Profile Editing.
    
6. Lofting with Guide Lines
   You can specify guides lines when creating the loft object. In this example, the lower circle and upper square are the loft profiles. The four curves between the profiles are guide lines.
   Image Modified
7. Activate Activate Loft, and select the loft profiles in the desired order.
   Image Modified
8. Click Click Select Guide Lines, or select it from the local menu.
   Image Modified
9. Select each of the guide lines.
   Image Modified
10. Click Click Finish or  or select it from the local menu. The 3D object transitions between the loft profiles, following each of the guide lines.
    Image Modified 
    Guide Lines
    Guide lines can be arcs, 2D or 3D Splines or lines. Beziers, and polyline cannot be used as guide lines. Guide line must touch every profile used in the loft. One end of each guide line must terminate on the first profile used in the loft The other end of that guide line must terminate on the last profile used in the loft. If guide lines do not meet these requirements they will be ignored.

Lofting Shape Properties

The The Properties window  window of a loft contains a a Lofting Shape page page, in which you can minimize twist.
Image Modified 
Miinimize Twist
Image Modified 
Effect of Minimize Twist For
For TC Surface Options, see see TC Surface Properties.