Page Comparison

AnchorRt3D17594PRt3D17594PAvailable in TurboCAD Platinum only_
Image Modified
Adds a bend onto a solid (ACIS) cylinder.

1. Start with a cylinder, and activate Tube Flange. Select the cylinder you want to bend. The next click defines the end where the flange will be added.
   Image Modified
2. The next click defines the AnchorXt3D136459Xt3D136459 AnchorXt3D136467Xt3D136467, which defines the direction of the bend, relative to the axis of the cylinder.
   Image Modified
3. This angle can be set in the Inspector Bar as well. You can also define the Radius and Angle here.
   Image Removed Image Added
   The Neutral Depth is the distance into the depth of material, along which there will be no tension or compression. Flange Length is the length of the new material beyond the current end of the cylinder.
   The preview shows how the final result will look. You can still make changes to any value in the Inspector Bar.
   Image Modified
4. Select Finish from the local menu or Inspector Bar to complete the bend.
   Image Modified
   You can use this tool multiple times on the same cylinder.
   Image Modified