Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Geo-Location

Available in TurboCAD Pro, and Platinum only

Geo-Location contains three primary functions: Location, Orientation, and Display.


Location

  • Latitude - set the latitude of the drawing in degrees, to six decimal places.
    • South/North - specify whether the latitude angle is South or North
  • Longitude - set the longitude the drawing in degrees, to six decimal places.
    • East/West - specify whether the longitude angle is East or West

Coordinates and Elevation

    • X, Y, Z - specify the location in the drawing which corresponds to the geo-location. Units are in the model space defined Space units.
    • Elevation - specify the elevation of the drawing at that geo-location.
    • Marker
      • Show - When on this shows a crosshair marker within the drawing, located at as specified by the X, Y, Z values. This maker can be snapped to as a drawing reference.
      • Size - Sets the relative size of the to the crosshair marker.

North Direction

    • Angle - Specify the Angle of orientation for North relative to the drawing.
    • Marker - Displays a compass rose for drawing orientation
      • On Screen Position - Specify the location of the compass rose: Not Display, Top Left, Bottom Right, Top Left, and Bottom Left.
      • Size-- Sets the relative size of the compass rose: Tiny, Small, Normal, and Large.

...