Controls the display of TurboCAD warning messages. If you received a warning message with the "Don't show this message again" checkbox, the warning message will appear in this table. Use the Show column to show or hide messages.UI enhancements of the Warning dialogs page
Introduction
A few UI enhancements were made at the Warnings Dialogs Page. Below there is a list of them:
...
Show/hide list columns.
By a right mouse Right click on the header of the list ctrl it is possible to call open the local menu which gives a possibility . This make it possible to show/hide list columns (fig. 1). . NOTE: The first three columns are always visible.Anchor
Figure 1 Local menu for Show/Hide list ctrl columns
...
Setting the value in the 'Default' and 'Log' columns
The left mouse click at the appropriate Left clicking in a cell in the 'Default' or 'Log' column will cause the combobox appearing (fig. 2) and give a possibility to change the value of the cell (fig.3).
Figure 2 Combobox appearing
Figure 3 Changing of the cell value via combobox
3. The ability to sort columns in the appropriate order
The ability to sort columns is available by a combobox to appear, allowing you to set the setting of that cell.
Sorting Columns in the appropriate order
Columns can be sorted in two ways:
- Via left mouse click at the header of the appropriate column
- Via local menu command (fig. 4). This local menu can be called via a right mouse click at the space of within the list control.
The default sorting is the sorting by 'Time' column in ascending order.
Figure 4 Local menu with sorting commands
...
Filtering the contents of the list
...
The ability to filter the contents of the list is available via the local menu commands (fig. 5). This local menu can be called via a right mouse click at within the space of the list control. Here it is possible to see the following commands:
...
list
The filtering commands are:
- Show diagnostic - in addition to the normal (base) content of the list it is need to add specific also show specifically diagnostic messages. FALSE by default.
- 'Show fixed visibility'. Means that in - in addition to the normal (base) content of the list it is need to add messages which should always (or never) appear (by other word those messages whose also show messages for which the 'Show' state can not be changed). FALSE by default.
- 'Show only appeared'. Means to show in the list - Show only those warnings which were have already appeared. If this option TRUE the content of the list is equal to the contents of this list in the all previous TurboCAD versions. TRUE by default.
Figure 5 Commands of the local menu for the filtration of the list contents
...
Changing Multiple 'Log' or "show' Settings
Since the cells in the 'Log' column can have only two values ('Yes' and 'No'), it is very convenient to change the value for the multiple selected cells (as it is also possible to do this with the first 'Show' column). Such possibility This is now available possible through the local menu command (fig.6). This local menu can be called via right mouse click at the space of the list control.
Figure 6 Set 'Log' column value for multiselection.
For Log:
Simply use Click and SHIFT to select the cells, then open the local menu and select the appropriate yes or no option.
For Show
Simply use Click and SHIFT to select the cells, check or un-check the option box.