...

1. Create the base rectangle by selecting its opposite corners. You can also enter the length and width in the Inspector Bar. The rectangle is created on the current workplane.The order of selecting points is important - the wedge will be extruded from the second point.
   
2. Select a third point to specify the wedge height, or enter the height in the Inspector Bar. You can create the wedge on either side of the workplane. Image Removed

...

1. 
   Image Added

Wedge Properties

The Properties window of a wedge contains a Wedge page, in which you can set the geometric parameters.

For TC Surface Options, see TC Surface Properties.