Page Comparison

AnchorRace26969PRace26969P.
Advanced controls for the frequency and locations of grid lines. See Grid. Image Removed
Fre AnchorXace125742Xace125742quency: Enables you to alternate visible grid lines with invisible grid lines. For example, if you set the frequency to 4, every fourth grid line will be displayed. You will still be able to snap to invisible grid lines.
Min AnchorXace125744Xace125744or: Controls for the intermittent (lighter by default) grid lines.
None: No minor grid lines will be displayed.
Divisions: Establishes the number of minor grid lines by setting the number of divisions between each major grid point.
Offset: Creates minor grid points at a fixed distance from each major grid point. Negative values can be used.
Origin: Enables you to use a "local" grid. By default, the grid origin is located at the origin of the coordinate system, at (0,0). You can reset the origin point of the grid and change the base angle, aligning the grid to a non-orthogonal object. For example, you can orient the grid of a house to its lot.

Image Added
 

...

Note: Set Grid Origin is also accessible from the Grid toolbar.

Perspe AnchorXace165881Xace165881ctive Perspective grid: Relevant when the grid is displayed and you are working in Perspective mode.

By Drawing: An infinite grid will be displayed.

By Size: The size of the displayed grid is determined by Perspective grid extents. This value sets the grid extents in both directions from the WCS origin, i.e. a value of 3 inches will produce a 6 x 6 grid. Image Removed

Image Added