Page Layout Wizard
The Page Layout Wizard is designed to expedite the creation of Paper Space Layouts for 3D models and projects.
...
Auto: Everything is automatic, except the selection of the pre-existing project.
New: Create an entirely new project.
Use: Use an existing project with or without modifications. When the Use option is selected you will be prompted to specify the *.PLX file that contains the desired project.
Modify: Modify an existing project without using it.
Use margins information from defined printer: Use the margin settings from the selected printer to define the margins of the generated Paper Space Layouts. This option is not available in the Modify mode.
Create page layouts for all 3D entities in the drawing: This option will only be available if the Use mode is selected. With this option ALL 3D entities in the drawing will be used for creation of the View/Viewports and Drafting palette components. If you do not select this option you will be prompted to select the required 3D entities in the drawing space.
For optimal efficiency and performance two modes are provided for the creation of layout components:
Architectural: This mode is faster with less demands on system resources, but non-associative
Mechanical: This mode is associative, but is slower, and places greater demands on system resources. Note: You can use the Architectural mode for mechanical models and vice-versa but there is a potential for reduced
...
- Position the mouse, and then click to set the dashed line as the section line.
2. The next prompt is a box. Position the mouse and click again to set the depth and width of the section area.
3. After the second click the depth and width of the section box will be set. Now position the mouse and click a third time to set the height of the section.
When you have selected the third position the section will be set and the wizard will reappear.
Resetting a Section
To reset a section, select that section in the Page Layout area, and then right-click over the section in the Layout Page area. Choose Reset Section Line from the popup menu.
A warning will appear on the section saying that the Section Line is not defined. Use the Set Section Line option to set the section correctly.
...