Controls the measurement and display of angles, as well as control over the Ortho angle.
Angular System: Select degrees, degrees-minutes-seconds, grads, radians, or the surveyor system.
Bas
e angle: The default base angle is 0 degrees (right quadrant point). You can change this value to start angle measurement from another base angle. Anchor Xace125813264Xace125813 264
Precision: The number of decimal digits.
Direction: Choose whether to measure angles clockwise or counterclockwise.
Ortho Angle: By default, Ortho lines are 0 and 90 degrees. You can change this by entering new values here.
Base angle: Sets the angle from which the Ortho angle is measured.
S
tep angle: The angle to which Ortho constrains lines. If you set the step angle to 15, for example, the line will be constrained to angles 15 degrees apart. The default step angle is 90 degrees. Anchor Xace125819265Xace125819 265
Page Comparison
Manage space
Manage content
Integrations