...
Available in TurboCAD Pro, and Platinum LTE Pro / DoubleCAD Pro only
Geo-Location contains three primary functions: Location, Orientation, and Display.
Location
- Latitude - – set the latitude of the drawing in degrees, to six decimal places.
- South/North - – specify whether the latitude angle is South or North
- Longitude - – set the longitude the drawing in degrees, to six decimal places.
- East/West - – specify whether the longitude angle is East or West
Coordinates and Elevation
- X, Y, Z - – specify the location in the drawing which corresponds to the geo-location. Units are in the model space defined Space units.
- Elevation - – specify the elevation of the drawing at that geo-location.
- Marker
- Show - – When on this shows a crosshair marker within the drawing, located at as specified by the X, Y, Z values. This maker can be snapped to as a drawing reference.
- Size - – Sets the relative size of the to the crosshair marker.
North Direction
- Angle - – Specify the Angle of orientation for North relative to the drawing.
- Marker - – Displays a compass rose for drawing orientation
- On Screen Position - – Specify the location of the compass rose: Not Display, Top Left, Bottom Right, Top Left, and Bottom Left.
- Size-- Sets the relative size of the compass rose: Tiny, Small, Normal, and Large.
Geo-Location Crosshairs and Compass Rose 