...
Note: To move (or copy) objects relative to specific points or objects, see Assembling
...
1. Select the objects you want to move. (See Components of Select Edit Mode if you want the reference point in a different place.)
2. Click the reference point, and the cursor changes to a four-directional arrow. Move the reference point to the new location, or enter the new position in the Inspector Bar.
...
Note:You can make a copy by clicking the reference point, pressing Ctrl, and then locating the new reference point.
...
3. When the objects are moved, click anywhere or press Esc to exit Select mode.
Moving along One Axis
You can move or drag an object along the X or Y axis (or Z for a 3D object by clicking and moving the axis handle itself.
Simple Dragging
If you place the cursor anywhere inside a selection other than on the reference point, you can simply drag the selection (keeping the mouse pressed) to another location within the drawing. With simple dragging, you cannot use snaps or the Coordinate Fields, but it is convenient if you do not need accurate placement.
...
Warning: The behavior of snap modes is slightly unusual when you are moving an object using OLE drag and drop. It is therefore not a recommended method for moving objects that require precise placement.
...