Available in TurboCAD Pro and Platinum only

 
Pulls or pushes a 3D extension of a face by extruding 2D a closed area on the face of a 3D object. The extrusion extends along a path normal to the face of the 3D object.

The closed are must be coplanar co-planar with the Flat face of a 3D object. It may consist of:

Any closed 2D entity. E.g. a rectanglrectangle

Any area that can be hatched by picking a point (with zero gap tolerance)

Areas enclosed by crossing coplanarco-planar, linear geometry, including edges and geometry in blocks E.g. intersecting lines that create a closure

...

Any combination of the above. Areas created by geometry (including edges on faces) drawn coplanar co-planar to any face of a 3D solid E.g. A circle is coplanar co-planar with the face of a cube. It overlaps the edge of the cube. The edge divides the circle into two parts, one is a valid area, or intersecting lines that create a closure on the face of a 3D object, with or without defining geometry of the 3D entity.

...

1. If you are specifying the height by using the mouse, click to finish the extrusion.
   Or
   If you are specifying the height by using the height field in the Inspector bar, press Enter to finish the extrusion.

Always Create Solid

Image Added

When this option is on the Quick Pull tool ignores the Part Tree and creates a ACIS Solid as the result.

...

Note: If the Two Sided property is set, the solid extrusion will be created on either side of the profile.

...

Offset: Creates a hole in the extrusion at a distance from the outside of the extrusion equal to the Offset value.

...

...