Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Available in TurboCAD LTE Pro / DoubleCAD Pro only


Enables you to change the top height of a wall by trimming or extending it to a single-line object.The object can be a line, arc, or polyline. It must be at least as long as the wall, and cannot extend below the bottom of the wall. In addition, it must lie in the same workplane as the wall.
Note: The way to assign height to a wall is to open its Properties to the 3D page and enter a Height.

...