Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Available in TurboCAD Platinum only

 
Creates a 3D object by extruding (sweeping) a 2D open or closed profile along a path normal to the workplane of the 2D object and imparting a twist. If you extrude an open profile, a surface will be created.

  1. If you want to select only a simple (single-object) curve, make sure Use Compound Profile is not selected.
  2. If you want to use a compound profile, which is a series of connected lines and/or arcs, select Use Compound Profile.
  3. If necessary, select Finish Selection of Profile to continue.
  4. Select the 2D open or closed profile to extrude. Move the mouse to extrude the profile, or enter a value in the Height field of the Inspector Bar.
     
    If you select an open profile, the resultant object will be a surface.
     
    If you select Two Sided Extrude, the solid extrusion will be created on either side of the profile.

...

 
Draft Start / End Distance: If Draft Angle = 0, you can specify a draft angle by entering the offset distances.

ffsetOffset: Creates a hole in the extrusion at a distance from the outside of the extrusion equal to the Offset value.

...