Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Image Modified
Creates an arc tangent to an arc, circle, or ellipse.

  1. Select the existing arc, circle, or ellipse to which you want the arc to be tangent. The tangent circle, from which the arc will be cut, extends from the point you selected.
    Image Removed Image Added
  2. Select the centerpoint of the tangent circle, or enter the radius, diameter, or circumference in the Inspector Bar. (If you use the Inspector Bar and then press Enter, you will not be able to reposition the circle.)
    . The circle will be created from the point you selected on the tangent object.
    Image Removed Image Added
  3. Move the mouse to position the circle, either inside or outside the tangent object.
     
    Image RemovedImage Added
  4. A dotted line appears from the centerpoint. Move the cursor to set the arc start angle, or enter the angle in the Inspector Bar.
    Image Removed Image Added
  5. Move the cursor counterclockwise to draw the arc, or enter the end angle or arc length in the Inspector Bar.
    Image Removed Image Added