Versions Compared

Old Version 2

changes.mady.by.user Zunair Attif IMSI

Saved on

compared with

New Version Current

changes.mady.by.user Zunair Attif IMSI

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: corrected "verment mode" to segment mode in point 4

...

  1. Enter the number of sides in the Inspector Bar. If desired, you can also specify the Angle (angle of control point from the center), and Radius or Side (length of one side).
  2. Select the mode: Vertex, Segment or Edge.
  3. If you are using Vertex or Segment mode, select the polygon centerpoint.
  4. Use the default Verment Segment Mode from the local menu or Inspector Bar to use the midpoint of one segment as a control point.
  5. Or, select Edge Mode from the local menu or Inspector Bar to use the midpoint of one segment as a control point.

...