Geo-Location

Available in TurboCAD Pro, and Platinum only
Geo-Location contains three primary functions: Location, Orientation, and Display.

Location

Latitude - set the latitude of the drawing in degrees, to six decimal places.
- South/North - specify whether the latitude angle is South or North
Longitude - set the longitude the drawing in degrees, to six decimal places.
- East/West - specify whether the longitude angle is East or West

Coordinates and Elevation

- X, Y, Z - specify the location in the drawing which corresponds to the geo-location. Units are in the model space defined Space units.
- Elevation - specify the elevation of the drawing at that geo-location.
- Marker
  - Show - When on this shows a crosshair marker within the drawing, located at as specified by the X, Y, Z values. This maker can be snapped to as a drawing reference.
  - Size - Sets the relative size of the to the crosshair marker.

North Direction

- Angle - Specify the Angle of orientation for North relative to the drawing.
- Marker - Displays a compass rose for drawing orientation
  - On Screen Position - Specify the location of the compass rose: Not Display, Top Left, Bottom Right, Top Left, and Bottom Left.
  - Size-- Sets the relative size of the compass rose: Tiny, Small, Normal, and Large.

Geo-Location Crosshairs and Compass Rose