You can find any tool by the Menu Structure HERE: https://turbocaddoc.atlassian.net/wiki/display/TC20UG/Menu+Structure

You can find the menu location of any tool by name HERE: https://turbocaddoc.atlassian.net/wiki/display/TC20UG/Tools+Mapped+to+Menus

Arc_3 Points

Owned by Brian Carter (Unlicensed)
Last updated: Jan 17, 2013
1 min read

Creates an arc by defining the start point, a point on the arc, and the endpoint. This is a "generic" arc tool, because the local menu options enable you to define the arc in a number of different ways.

Select the start point.

Select a point through which the arc will pass.

Select the endpoint.

Local Menu Options:

  • Center: Before you click the arc start point, you can select Center to define the center point first.You can then click the center point and start point.
  • Rather than clicking the end point, you can select the Angle or Chord Length local option.
  • End: With this option, after you click the arc start point, you can select End to click the end point.
  • Then you can click the center point, or use the Angle, Direction, or Radius local option.

 

Â