You can find any tool by the Menu Structure HERE: https://turbocaddoc.atlassian.net/wiki/display/TC21UG/Menu+Structure

You can find the menu location of any tool by name HERE: https://turbocaddoc.atlassian.net/wiki/display/TC21UG/Tools+Mapped+to+Menus

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Current »

Available in TurboCAD Pro, and Platinum only

Geo-Location contains three primary functions: Location, Orientation, and Display.


Location

  • Latitude – set the latitude of the drawing in degrees, to six decimal places.
    • South/North – specify whether the latitude angle is South or North
  • Longitude – set the longitude the drawing in degrees, to six decimal places.
    • East/West – specify whether the longitude angle is East or West

Coordinates and Elevation

    • X, Y, Z – specify the location in the drawing which corresponds to the geo-location. Units are in the model space defined Space units.
    • Elevation – specify the elevation of the drawing at that geo-location.
    • Marker
      • Show – When on this shows a crosshair marker within the drawing, located at as specified by the X, Y, Z values. This maker can be snapped to as a drawing reference.
      • Size – Sets the relative size of the to the crosshair marker.

North Direction

    • Angle – Specify the Angle of orientation for North relative to the drawing.
    • Marker – Displays a compass rose for drawing orientation
      • On Screen Position – Specify the location of the compass rose: Not Display, Top Left, Bottom Right, Top Left, and Bottom Left.
      • Size-- Sets the relative size of the compass rose: Tiny, Small, Normal, and Large.

Geo-Location Crosshairs and Compass Rose
 

 

 

  • No labels