$customHeader
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 5 Current »

The Autoshape tool is a special drawing tool that lets you quickly sketch in shapes. You simply drag your finger to sketch out the approximate shape and the Autoshape tool will turn your sketch into the appropriate object. The possible results are: 

  • A Rectangle
  • A Circle/Ellipse
  • A Cloud
  • A Curve
  • A Polyline, closed or open
  • 5 Pointed Star

To draw an Autoshape:

  1. Select the Autoshape tool
  2. Place your finger on the screen where you want the shape to begin.
  3. Drag your finger in the shape you want to create.
  4. Lift your finger off the screen. This completes the shape.
  5. To make a closed shape lift your finger at the same point where you began the shape.

Editing Autoshapes

Since the autoshape tool creates standard shapes, rectangle etc., those shapes are edited by their type. However the Autoshape tool also creates three additional types: Polyline, Curve, Star (5 pointed).

Circle

A circle is drawn If the shape approximates a circle and the radiii are nearly equal.

Ellipse

A circle is drawn If the shape approximates a circle and the radiii are not equal.

Line 

A line is drawn If the shape approximates a line.

Polyline

If end points are located near to each other, the polyline will be closed.

If the angle between two consecutive line segments are approximately 90 degrees, a right angle is created. 

A closed polyline with 3 points will result in a triangle - It can be a right-triangle, equilateral or isosceles.

Closed polyline with 4 points can be recognized as rectangle, square, parallelogram, trapezoid.

If end point of parallel side in a quadrangle is moved along parallel lines, the property of parallelism is being kept.

Right angles in quadrangle are adjusted as well.

Another form of polyline - star. At the input regular star is automatically generated, later it can be made irregular. Star can be edited by moving end points or inner/outer radius points.

Curved line is approximated by spline, it can be closed and unclosed
Autocloud is created when  closed curved line can be approximated with a cloud markup

 

  • No labels