Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Current »


Creates a line perpendicular to an existing line.


Tip: This tool creates a line from an existing line. To create a perpendicular line to a line, you can use the "J" SEKE (see Running and Local Snaps.


  1. Select an existing line.

  2. Select the point on the existing line where the perpendicular line will start. You can select a point past the endpoints.

  3. Select a third point to set the length of the perpendicular line, or enter the length in the Inspector Bar.

    Local menu option: 
    Li mit to Segment: The perpendicular line cannot extend past the endpoints of the existing line.


    Tip: To draw a line perpendicular to an arc or circle, draw a single Line from the center of the arc or circle to its destination, then trim the line.
  • No labels