Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Current »

The Miter Two Roof Slabs tool allow you to bring two Roof Slabs together with a smooth joint.

The tool has a single option in the local menu: By Intersection

Use this option when you are mitering two intersecting roof slabs. Both roof slabs are trimmed along the intersection of their perimeter lines. Vertices are added or removed as required. The new edges of the roof slabs are set to angles required for a true miter cut. If the slab thicknesses of the two edges are different, the angles will be different You cannot use this option if the slabs do not intersect.

To Miter Two Intersecting Roof Slabs:
 

  1. Select the first roof slab on the part of the slab you wish keep. The opposite side will be trimmed.
     
  2. Select the second roof slab on the part of the slab you wish keep. The opposite side will be trimmed.
  3. The result will look like this. 
     

 

 

If the two Roof Slabs do not intersect you can miter two slabs by selecting edges to extend and meet (similar to the 2D Meet 2 Lines tool).  Only one edge of each roof slab is mitered. You can miter edges of roof slabs without altering the entire slab. To accomplish this, however, you may need to insert additional vertices.

  1. Make sure that the By Intersection option is off in the local menu.
  2. Select one edge on the first roof slab.
  3. Select one edge on the second roof slab.
  4. The result will look like this:

Another example:

 

 

 

 

  • No labels