You are viewing an old version of this page. View the current version.
Compare with Current
View Page History
« Previous
Version 2
Next »
Available in TurboCAD Pro Platinum, Pro and Deluxe only
Menü: Zeichnen, Nut, Nut
Creates a straight slot.
- Define the segment start point.
- Define the endpoint, or specify the length and angle in the Inspector bar.
- Define the width, or specify the width or half-width in the Inspector bar.
(without rounded ends)
Options:
- Rounded Ends: Specifies that the slot is to be drawing with rounded ends. This option is on by default.
- Draw as Polyline: Specifies that the slot be drawn as a polyline.
Properties:
- Rounded Ends: Specifies that the slot is to be drawing with rounded ends. This option is on by default.
- Trim Ends: Specifies that the ends of the slots terminate at the node points. This property is only available if Rounded ends is turned off.
Node Editing a Slot
A Slot can be node edited just like a single line segment.
