This manual serves as the User Guide for all TurboCAD LTE 5/ DoubleCAD 5 Products

Pick Point Hatching

Owned by Brian Carter (Unlicensed)
Last updated: Jul 25, 2012Version comment
1 min read

Pick Point Hatching is an enhanced version of Pick Point Hatch.
Applies a hatch pattern to a closed boundary, by clicking one point within the desired boundary. This tool recognizes overlaps and islands.

  1. With Pick Point Hatching you can pre-set the hatch's pattern Line Color, Line Pattern, Line Width, Brush Color and Brush Pattern from the Properties toolbar directly above the drawing area.
  2. Activate Pick Point and Hatch.
  3. Click any point within the desired boundary to create the hatch.
  4. You can hatch additional areas by clicking until you cancel out of the tool.