This manual serves as the User Guide for all TurboCAD LTE 8 / DoubleCAD 5 Products
Arc_ Start, End, Direction
- Brian Carter (Unlicensed)
Owned by Brian Carter (Unlicensed)
Menu: Draw / Arc / Start, End, Direction 
Creates an arc by defining its start point, end point, and tangent direction.Note: You can use the local menu options to create this arc differently. See the local menu options for "Arc: 3 Points" on page 179.
- Select the arc start point and then the end point. You can also specify the Length and Angle in the Inspector Bar.
- Move the cursor to set the tangent direction of the arc, or enter the Angle in the Inspector Bar.
