This manual serves as the User Guide for all TurboCAD LTE 8 / DoubleCAD 5 Products
Arc_ Start, Center, End
- Brian Carter (Unlicensed)
Owned by Brian Carter (Unlicensed)
Menu: Draw / Arc / Start, Center, End 
Creates an arc by defining its start point, the center point, and the end point.Note: You can use the local menu options to create this arc differently. See the local menu options for "Arc: 3 Points" on page 179.
- Select the arc start point and then the center point. You can also specify the Radius and Angle in the Inspector Bar.
- Move the cursor counterclockwise to draw the arc, or enter the End Angle in the Inspector Bar.
