Gesture Settings

The 2D/3D Navigation - controls whether using 1-finger will Pan or 3D orbit your drawing file. Setting it to ON will automatically detect if the drawing has objects drawn on the positive or negative Z plane or not. If no objects are drawn on the Z plane, then it will run in 2D Pan navigation mode. If objects are drawn on the positive or negative Z plane, then 3D orbit mode will be activated. Setting it to OFF will force 1-finger navigation to be 2D Pan only.
Free Transform - sets orbit mode. Setting it to On will set the 2-finger gesture to perform a tumble rotation orbit, setting it to Off will set it to a constrained orbit.

GeoWalk Settings

GPS -- Specifies that GPS and analogs should be used to track motion.

SPS™ -- Species that Sensors should be used to track motion.

Calibrate Settings

Slow/Fast – Specifies the degree of acceleration that should be used by GeoWalk to determine a step has been taken.

Light/Heavy -- Species the delicacy of your steps to be used by GeoWalk to estimate distance.

Smooth/Choppy - Specifies the degree of difference in acceleration between steps to be used by GeoWalk

Reset – Resets all values to factory settings.

Run Calibration Wizard – Runs the GeoWalk wizard to auto-calculate the GeoWalk settings.

To Use the Wizard:

Click Run wizard.
Take several steps and tap the white bar with each step
Then tap Stop wizard.

Warnings Settings

Low Memory Warnings - Turn ON to view messages about low memory.

File Conversion Warnings - File conversion is done using TurboConvert file conversion using our Cloud Server. Set this option to ON to be prompted about converting your file over the cloud, set to OFF for no messages.

Deleting Geometry Warnings - Set this option to ON to be prompted about deleting selected markup geometry, set to OFF for no messages.

Quality Settings

Photo Resolution - Specifies the resolution for photos and screen shots. Lower values save memory.

Video Resolution - Specifies the resolution for recorded videos. Lower values save memory.