Roof Wall Modifier

Available in TurboCAD LTE Pro / DoubleCAD Pro only


Enables you to extend the Top height of a wall to meet the roof. This is especially important if you have edited the Slope angle of a roof so that you have an open gable end.
Note: The way to assign height to a wall is to open its Properties to the 3D page and enter a Height.

  1. Select the Roof Wall Modifier tool.
  2. Select the wall you want to modify..
  3. Select the roof to which you want the wall to extend. !worddav80ff9507d77c18b47014252e58675e50.png|height=331,width=366!The wall will now extend to the roof.Top Wall Modifiers will override Roof Wall Modifiers, and Roof Wall Modifiers will override Top Wall Modifiers, but you can use Bottom Wall Modifiers, in conjunction with Roof Wall Modifiers.