Spherical Pattern

Available in TurboCAD Platinum only

  1. Select the Spherical Pattern tool.
  2. In the Inspector bar set the Number of latitudes.
  3. Select a 3D solid.
  4. Click to set the center of radial pattern.
  5. Click to set the radius of the pattern.





Create Association: Creates an association between the pattern and the destination object. If subsequently the destination object is edited the pattern will update to reflect the changes made. The Leave Destination and By Entity options must be active for associations to be available.

Leave Source: If this option is on the original 3D object (source) will remain. If it is off the object will be deleted.

Leave Destination: If this option is on the 3D object used as for By Entity will remain. If it is off the object will be deleted.

Â