Slot

Available in TurboCAD Pro Platinum, Pro and Deluxe only

Creates a straight slot.

1. Define the segment start point. 
   
2. Define the endpoint, or specify the length and angle in the Inspector bar.
3. Define the width, or specify the width or half-width in the Inspector bar.
   
   (without rounded ends)
   
   
   

Options:

• Rounded Ends: Specifies that the slot is to be drawing with rounded ends. This option is on by default.
• Draw as Polyline: Specifies that the slot be drawn as a polyline.

Properties:

• Rounded Ends: Specifies that the slot is to be drawing with rounded ends. This option is on by default.
• Trim Ends: Specifies that the ends of the slots terminate at the node points. This property is only available if Rounded ends is turned off.

Node Editing a Slot

A Slot can be node edited just like a single line segment.