Circular Slot by Center and Radius
Available in TurboCAD Pro Platinum, Pro and Deluxe only
Creates an circular arc slot by defining its center, a point on its circumference, and the start and end angles and width.
- Select the arc centerpoint and a point on the circumference of the circle from which the arc will be cut. You can also specify the radius, diameter, or circumference in the Inspector Bar.
- A dotted line appears from the centerpoint. Move the cursor to set the arc start angle, or enter the angle in the Inspector Bar.
- Move the cursor counterclockwise (you can change this to clockwise with the Angle options) to draw the arc, or enter the end angle or arc length in the Inspector Bar.
- Define the width, or specify the width or half-width in the Inspector bar.
(without rounded ends)
Slots can be combined using the 2D Boolean tools (Add, Subtract, Intersect)